Table of Contents
Advertisement
TeleTek
ADDRESS 50
ENGINEER CODE CHANGE
In this address a new access code to the engineer parameters of the control
panel is set. On the keypad display the LEDs: 3, 4, 5 and 6 light. After each
entering of a digit of the new code, one LED stops lighting. Confirmation of the
new code is required.
The engineer code is programmed.
ENGINEER CODE
DEFAULT : 7777
ADDRESS 51
HARDWARE RESET BLOCKING
In this address the hardware RESET of the control panel is enabled/disabled.
In case the hardware RESET is disabled and the engineer code is
unknown, the programming menu is not accessible.
The hardware RESET is disabled. The LEDs from 1 to 6 do not light.
NO
The hardware RESET is enabled. The LEDs from 1 to 6 light.
YES
DEFAULT : YES
ADDRESS 52
DEFFAULT PARAMETERS RESETTING (SOFTWARE RESET)
Control panel default parameters reseting. The 1, 2, 3, 4, 5, 6 keys are pressed
DEFAULT
in sequence and confirmed by ENTER. The system begins charging the default
SETTINGS
parameters.
ADDRESS 53
DEFFAULT MANAGER CODE RESETTING
Control panel default manager code (0000) reseting. The 1, 2, 3, 4, 5, 6 keys are
DEFAULT
pressed in sequence and confirmed by ENTER. The system recharges the
MANAGER CODE
default manager code.
ADDRESS 54
PHONE NUMBER FOR REMOTE PROGRAMMING
In this address the phone number for remote programming from the remote PC
Tel No for
is set. Hexadecimal indication. The maximum lenght of the phone number is 16
Up / Down Load
symbols, including the pause symbols (ON and 2) and the symbols for entering
a DTMF dialing (ON and 1).
DEFAULT : No phone number entered
ADDRESS 55
REMOTE PC ACCOUNT NUMBER FOR REMOTE
PROGRAMMING
In this address a remote PC account number for remote programming is set. On
the keypad display the LEDs: 3, 4, 5 and 6 light. After each entering of a digit of the
new account, one LED stops lighting. Confirmation of the new account is required.
The remote PC account number for remote programming is programmed.
PC ID
DEFAULT : 1234
ADDRESS 56
CONTROL PANEL ACCOUNT NUMBER FOR REMOTE
PROGRAMMING
In this address a control panel account number for remote programming panel is set.
On the keypad display the LEDs: 3, 4, 5 and 6 light. After each entering of a digit of
the account, one LED stops lighting. Confirmation of the new account is required.
The control panel account number for remote programming is programmed.
PANEL ID
DEFAULT : 1234
CA60Plus
5. ENGINEER PARAMETERS
21
Installation Manual
Hide quick links:
Advertisement
Table of Contents
