Led Keypad Wiring - Teletek electronics CA60Plus Installation Manual

TeleTek
1
4
7
CLR
1
2
5
4
8
7
ON PROG
The CA60Plus control panel keypad is wired by the manufacturer with a 20 cm long cable bundle.
While connecting the bundle to the panel have in mind the colour match of the different wires (See
Fig.4).
The cables for the zone in the keypad are white and black.
The zone in the keypad should not to balanced.
Up to three keypads may be connected in parallel to one security panel.Each keypad should be set
with his own address. This could be done by mounting a jumper in a specified place inside the keypad
(See Fig. 5).
The keypad addresses are set by jumpers:
• • • • • JT - the first keypad address
• • • • • J0 - the second keypad address
• • • • • J1 - the third keypad address
If there is only one keypad in the security panel it is obligatory that the JT jumper is installed. When
more than one keypad is used the JT jumper should be mounted in the most distant keypad.
The connecting wire between the keypad and the security panel should be no longer than 100 m
and with a section no less than 0,25 mm.
CA60Plus

4. LED Keypad Wiring

WHITE
BLACK
2 3
5 6
8 9
0 ENT
RED
GREEN
YELLOW
3
6 0
BLACK
9
CLEAR ENTER
Fig. 4Keypad - Panel Connecting
Re v1 .3
Fig. 5 Keypad Jumper
ZONE 1
DETECTORS WIRES
RED
GREEN
YELLOW
BLACK
SECURITY PANEL
TERMINALS
T eleT ek
C A 60P lu s
k ey b oa rd
J1 J0
R ev 2 .1
6
Installation Manual
JT