Teletek electronics CA60Plus Installation Manual page 24

TeleTek
ADDRESS 65 SUBSCRIBER ACCOUNT NUMBER 2
PANEL ID 2
DEFAULT : 9999
ADDRESS 66 COMMUNICATION REPORT 2
COMMUNICATION The communication report types to the monitoring station are listed in the table
REPORT 2
DEFAULT : 1
ADDRESS 67 REPORT FORMAT 2
x1
x2
DEFAULT : x2
ADDRESS 68 WAIT DIAL TONE
NO
YES
DEFAULT : YES
CA60Plus
This is the panel ID number for the secondary monitoring station. The lenght of
the number is 3 or 4 digits (depending on the report format - 3x or 4x). The 0
symbol is replaced by an A (See the hexadecimal programming table in Appendix
A).
below. The symbols from 0 to B could be used.
[0] User report - dialer
[1] SP=10 pps; HS=KO=1400Hz; Data=1900Hz; 3x1, 3x2, 4x1, 4x2;
[2] SP=10 pps; HS=KO=1400Hz; Data=1900Hz; EXT; 3x1, 4x1;
[3] SP=20 pps; HS=KO=1400Hz; Data=1900Hz; 3x1, 3x2, 4x1, 4x2;
[4] SP=20 pps; HS=KO=1400Hz; Data=1900Hz; EXT; 3x1, 4x1;
[5] SP=20 pps; HS=KO=2300Hz; Data=1800Hz; 3x1, 3x2, 4x1, 4x2;
[6] SP=20 pps; HS=KO=2300Hz; Data=1800Hz; EXT; 3x1, 4x1;
[7] SP=40 pps; HS=KO=2300Hz; Data=1800Hz; 3x1, 4x2;
[8] SP=40 pps; HS=KO=2300Hz; Data=1800Hz; EXT; 3x1;
[9] SP=40 pps; HS=KO=2300Hz; Data=1800Hz; 3x1, 4x2; Checksum;
[A] SP=40 pps; HS=KO=2300Hz; Data=1800Hz; EXT; 3x1; Checksum;
[B] ADEMCO CONTACT ID
[C]...[F] - reserved for future use
Choosing the format of the set report 3x1, 4x1. The LEDs from 1 to 6 light.
Choosing the format of the set report 3x2, 4x2. The LEDs from 1 to 6 do not
light.
Do not wait for DIAL tone before dialing. The LEDs from 1 to 6 do not light.
Wait for DIAL tone before dialing. The LEDs from 1 to 6 light.
24
Installation Manual