Aux 2 Pump Charts; Combustion Air Damper - CleaverBrooks CFC Operation, Service & Parts Manual

AUX 2
PUMP
Start Permissive
Interlock (e.g.

combustion air damper)

L/L Slave
Pump Configuration
On options
Central Heat:
DHW:
Local Lead Lag:
Frost Protection:
Aux pump:
*This setting may be inhibited due
to burner fault or disable
Logout
Pump Configuration
On options
Force pump off when:
DHW priority is active
DHW high limit
CH anti-condensation
DHW anti-condensation
*This setting may be inhibited due
to burner fault or disable
Logout
750-322
Pump Configuration
Pump control
Pump output
Pump start delay
Overrun time
Logout
Auxiliary 2 pump
Force on Force off
Misce
Local burner demand*
Demand* Service active*
Demand*
Service active*
Pump demand
Service active*
Central Heat DHW
X is set Y is set Z is set
Control
Settings>>
Auxiliary 2 pump
Force off
Force on
Misce
Control
Settings>>
Figure 18 - Aux 2 Pump
Auxiliary 2 pump
Auto
Pump A
0 sec
3 min
Use for local (Stand-alone) demands
Use for Lead Lag Master demands
Advanced
Settings>>
On options
Force pump on when:
Local burner demand*
Outlet high limit
Lead Lag slave demand
*This setting may be inhibited due
Logout
On options
Pump exercise interval
Pump exercise time
*Inhibit pump for burner fault or disable
Pump exercise settings apply to all
Logout
CB Falcon Lead/Lag
Pump Configuration
Auxiliary 2 pump
Force on
Force off Misce
Control
to burner fault or disable
Settings>>
Pump Configuration
Auxiliary 2 pump
Force on
Miscellaneous
Control
pumps Settings>>
33