Table of Contents
Advertisement
3-1/2
(89)
6-21/32
(169)
NOTE: This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to
part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference when the equipment is operated in a
commercial environment. This equipment generat-
eds, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instruction manual, may cause harmful interference
to radio communications. Operation of this equip-
ment is a residential area is likely to cause harmful
interference in which case the use will be required to
correct the interference at his own expense.
The Class A digital apparatus complies with Cana-
dian ICES-003
SAFETY FEATURES
The OI Display contains software that incorporates many
features that are designed to guide you safely through the
commissioning process. Safety, however, is your
responsibility.
Read all documentation carefully and respond appropriately to
all error messages
CB-8462
9-7/16 (240)
2
1
1
PANEL HOLE CUTOUT SIZE FOR FRONT PANEL MOUNT: 8 (203) WIDE X 5-1/2 (140) HIGH.
2
PANEL HOLE CUTOUT SIZE FOR REAR PANEL MOUNT: 7-1/8 (181) WIDE X 4-11/16 (119) HIGH.
Fig. 1. Display dimensions in inches (mm).
2
8-15/16 (227)
2
1
WARNING
Explosion Hazard.
Improper configuration can cause fuel buildup and
explosion.
Improper user operation may result in PROPERTY
LOSS, PHYSICAL INJURY or DEATH.
Using the OI Displays to change parameters, must be
attempted by only experienced and/or licensed
burner/boiler operators and mechanics.
INSTALLATION INSTRUCTIONS
The OI Display can be mounted on the door panel of an
electrical enclosure.
1. Select the location on the door panel to mount the dis-
play; note that the device will extend into the enclosure
at least one inch past the mounting surface.
2. Provide an opening in the panel door 8" wide X 5 1/2"
high (for front panel mount) or 7 1/8" wide X 4 11/16"
high (for rear panel mount). See Fig. 1 or use cutout
templates provided in Fig. 96 and Fig. 97.
3. Place the OI Display in the opening and use it as a tem-
plate to mark the location of the four mounting screw
holes. Remove the device.
4. Using pilot holes as guides, drill 1/4 in. holes through
the door panel.
5. Place the display in the opening, aligning the mounting
holes in the device with the drilled holes in the panel.
1-27/32
(47)
M32735
Advertisement
Table of Contents
Troubleshooting
