Table of Contents
Advertisement
Caution Before this instruction can be executed, MBE = 0 or (MBE = 1, MBS = 15) must be set.
Only 4 or 6 can be specified as n.
11.4.14 CPU Control Instructions
HALT
Function: PCC.2 <– 1
Sets the HALT mode. (This instruction is used to set bit 2 of the processor clock control register.)
Caution The instruction immediately following a HALT instruction must be a NOP instruction.
STOP
Function: PCC.3 <– 1
Sets the STOP mode. (This instruction is used to set bit 3 of the processor clock control register.)
Caution The instruction immediately following a STOP instruction must be a NOP instruction.
NOP
Function: Uses one machine cycle without performing an action.
11.4.15 Special Instructions
SEL RBn
Function: RBS <– n
Sets the 2-bit immediate data n in the register bank select register (RBS).
SEL MBn
Function: MBS <– n
Transfers the 4-bit immediate data n to the memory bank select register (MBS).
Only 0, 1, or 15 can be specified as n.
n = N
: 0 to 3
1-0
n = N
: 0, 1, 15
3-0
CHAPTER 11 INSTRUCTION SET
295
Advertisement
Table of Contents
