K Developer Clutch Removal - Lexmark C935 Service Manual

5057-XXX

K developer clutch removal

1. Remove the duplex unit assembly. See
2. Remove the fuser unit assembly. See
3. Remove the rear cover assembly. See
4. Remove the rear left middle cover. See
5. Remove the rear upper cooling fan bracket assembly. See
on page 4-111.
6. Remove the MPF feed unit assembly. See
7. Remove the developer / transfer roll HVPS card assembly. See
removal" on page
8. Remove the 24V LVPS card bracket assembly. See
9. Remove the CMYK transfer HVPS card assembly. See
page 4-104.
10. Remove the K developer transport drive assembly. See
removal" on page
11. Remove the E-clip securing the shaft (A) to the K developer / transport drive assembly (B).
12. Remove the busing (C).
13. Remove the shaft (A).
14. Disconnect the connector from the K developer clutch (D).
4-108
Printer Service Manual
"Duplex unit assembly removal" on page
"Duplex controller card assembly removal" on page
"Rear cover assembly removal" on page
"Rear left middle cover removal" on page
"MPF feed unit assembly removal" on page
4-112.
4-106.
Connector
"Rear upper cooling fan bracket assembly removal"
"Developer / transfer roll HVPS card assembly
"24V LVPS card bracket assembly removal" on page
"CMYK transfer HVPS card assembly removal" on
"K developer / transport drive motor assembly
4-10.
4-14.
4-5.
4-6.
4-8.
4-96.
Previous
Next
Go Back