Registration Clutch Removal - Lexmark C935 Service Manual

Registration clutch removal

1. Remove the rear cover assembly. See
2. Remove the rear left middle cover. See
3. Remove the MPF feed unit assembly. See
4. Remove the printer left door assembly. See
5. Remove the registration transport roll assembly. See
page 4-36.
6. Disconnect the connector from the registration clutch (A).
7. Remove the E-clip securing the registration clutch (A) to the registration transport roll assembly (B).
8. Remove the registration clutch (A).
Replacement note: Before reinstalling, ensure that the notch on the registration clutch (A) is placed over the
boss on the registration transport roll assembly (B).
Sensor (registration) removal
1. Remove the rear cover assembly. See
2. Remove the rear left middle cover. See
3. Remove the MPF feed unit assembly. See
4. Remove the printer left door assembly. See
5. Remove the two screws securing the plate (A) to the registration transport roll assembly (B).
6. Remove the plate (A).
7. Remove the screw securing the sensor (registration) (C) to the registration transport roll assembly (B).
8. Remove the sensor (registration) (C).
"Rear cover assembly removal" on page
"Rear left middle cover removal" on page
"MPF feed unit assembly removal" on page
"Printer left door assembly removal" on page
"Registration / transport roll assembly removal" on
"Rear cover assembly removal" on page
"Rear left middle cover removal" on page
"MPF feed unit assembly removal" on page
"Printer left door assembly removal" on page
5057-XXX
4-5.
4-6.
4-8.
4-26.
4-5.
4-6.
4-8.
4-26.
4-37
Repair information
Previous
Next
Go Back