5057-XXX
Warning: Note the orientation of the four developer unit harnesses and the three erase lamp harnesses to ensure
proper reinstallation or damage may occur.
14. While holding the four developer unit assemblies firmly inside the machine, gently remove the developer interlock
plate assembly (A).
15. Remove the developer interlock plate assembly (A) and allow it to gently hang down by the harness if removing the
developer units. If removing the developer interlock plate assembly (A) from the machine, goes to step 15.
16. Remove the screw securing the harness cover (B) to the machine.
17. Remove the harness cover (B).
18. Disconnect the connector from the developer interlock plate assembly (A).
4-50
Printer Service Manual
Previous
Next
Go Back