Printhead Assembly Removal - Lexmark C935 Service Manual

5057-XXX
16. Remove the CMYK toner add motor assembly (A).
CMYK transfer HVPS card assembly removal
1. Remove the rear cover assembly. See
2. Remove the rear upper cooling fan bracket assembly. See
on page 4-111.
3. Remove the rear left middle cover. See
4. Remove the developer / transfer roll HVPS card assembly. See
removal" on page
5. Remove the 24V LVPS card bracket assembly. See
6. Disconnect the two connectors from the CMYK transfer HVPS card assembly (A).
7. Disconnect the four faston connectors from the CMYK transfer HVPS card assembly (A).
8. Remove the two screws securing the CMYK transfer HVPS card assembly (A) to the machine.
9. Remove the CMYK transfer HVPS card assembly (A).

Printhead assembly removal

Warning: When removing the printhead assembly, be careful not to drop it, or damage will occur.
Warning: Always perform color registration adjustment when reinstalling the printhead, NVM initialization, or
developer interlock plate assembly.
1. Detach the finisher if equipped. Refer to the MFP or the Printer Finisher Service Manual.
4-104
Printer Service Manual
"Rear cover assembly removal" on page
"Rear left middle cover removal" on page
4-112.
"Rear upper cooling fan bracket assembly removal"
"Developer / transfer roll HVPS card assembly
"24V LVPS card bracket assembly removal" on page
4-5.
4-6.
4-96.
Previous
Next
Go Back