Sensor (Fuser Exit) Late Jam - Lexmark C935 Service Manual

5057-XXX

201.00 Sensor (fuser exit) late jam

Step
1 Check the media position.
Does the media touch the sensor (fuser exit)?
Check the fuser exit actuator.
2
Does the fuser exit actuator attached to the sensor (fuser
exit) appear to be binding or sticking in its normal resting
position and not allowing media to pass?
3 Check the 2nd transfer roll assembly.
Is the 2nd transfer roll assembly free of excess wear and
contamination?
4 Check the sensor (fuser exit) for proper operation.
1. Enter the Diagnostics Menu.
2. Select BASE SENSOR TEST.
3. Select Media Path.
4. Select Fuser exit.
Caution: The area around the actuator is very hot. Allow
the fuser area to cool before proceeding.
Does the display on the operator panel change every time
the sensing area of the above sensor is interrupted or
blocked?
5 Check the sensor (fuser exit) for proper connection.
Is the above component properly connected?
6 Check the duplex diverter gate solenoid for proper
operation.
1. Enter the Diagnostics Menu.
2. Select MOTOR TESTS.
3. Select Printer Motor Test.
4. Select Duplex diverter gate solenoid.
Does the above component operate properly?
2-28
Printer Service Manual
Check
Caution: When performing motor tests,
ensure that all cover and door interlock
switches are overridden.
Yes
Remove the Go to step 2.
media.
Replace the Go to step 3.
sensor (fuser exit)
Go to "Sensor
(fuser exit)
removal" on
page 4-25.
Go to step 4. Clean or replace
the 2nd transfer
roll assembly.
Go to "2nd
transfer roll
assembly
removal" on
page 4-35.
Go to step 6. Go to step 5.
Replace the Replace the
sensor (fuser exit). connection.
Go to "Sensor
(fuser exit)
removal" on
page 4-25.
Go to step 8. Go to step 7.
Previous
No
Next
Go Back