Motor Tests - Lexmark C935 Service Manual

C Channel (925.02)
K Channel (925.03)
Dev Unit Reset
Y Channel
M Channel
C Channel
K Channel
ENGINE ADJUST
PH Adjust (registration)
PRO-CON
RegCon Adjust
Booklet Fold Adj
Finisher Config
Booklet Fold Adjust
Booklet Tamper Shift Adj
Booklet Compile Position
Booklet 2-sheet
Booklet 15-sheet
Booklet Fold Pos Fine Adj
Booklet Staple Pos Fine Adj
Finisher Config
Exit Diagnostics Menu

MOTOR TESTS

The tests in this group allow you to test specific motors, and on some motors run them forward or reverse.
To run the MOTOR TESTS:
1. Select MOTOR TESTS from the Diagnostics Menu.
2. Select the test to run.
The following Finisher Motor Tests are available:
• Motor (entrance/paddle)
• Motor (buffer/transport)
• Motor (exit)
• Fin diverter solenoid
• Sub paddle solenoid
• Media eject clutch
• Media eject clamp motor
• Media eject motor
• Fin Buffer solenoid
• Punch carriage shift motor
• Punch unit motor
• Front tamper motor
• Rear tamper motor
• Stapler carriage motor
• Stapler unit motor
•
See "Dev Unit Reset" on page
See "ENGINE ADJUST" on page
See "Booklet Fold Adjust" on page
See "Finisher Config" on page 3-23
See "Exiting Diagnostics" on page
• Stacker bin lift motor
• Booklet end guide drive motor
• Booklet paddle drive motor
• Booklet front tamper motor
• Booklet rear tamper motor
• Booklet folding/exit drive motor
• Booklet media entrance drive motor
• Booklet transport motor
• Booklet knife solenoid
• Booklet bin media transport motor
• Bridge unit diverter gate solenoid
• De-curler clutch
• Bridge unit transport drive motor
• Booklet diverter gate solenoid
• Booklet stapler motor
• Bridge unit bin media exit solenoid
5057-XXX
3-19.
3-20.
3-23.
3-23.
3-5
Diagnostic aids
Previous
Next
Go Back