5057-XXX
Previous
Mounting hook
Next
Go Back
C
B
Printhead shutter motor assembly removal
1. Remove the rear cover assembly. See
"Rear cover assembly removal" on page
4-5.
2. Remove the rear left middle cover. See
"Rear left middle cover removal" on page
4-6.
3. Remove the MPF feed unit assembly. See
"MPF feed unit assembly removal" on page
4-8.
4. Remove the printer left door assembly. See
"Printer left door assembly removal" on page
4-26.
5. Remove the registration transport roll assembly. See
"Registration / transport roll assembly removal" on
page
4-36.
6. Disconnect the connector from the printhead shutter motor assembly (A).
7. Remove the two screws securing the printhead shutter motor assembly (A) to the machine.
8. Remove the printhead shutter motor assembly (A) from the machine.
4-79
Repair information