Rip Card Access Cover Removal - Lexmark C935 Service Manual

5057-XXX

RIP card access cover removal

1. Using your finger, lift the RIP card access cover (A) by the notch.
2. Remove the RIP card access cover (A).
RIP card assembly removal
Warning: In the event of replacement of any one of the following components:
•
RIP card assembly
•
Interconnect card assembly
Only replace one component at a time. Replace the required component, and perform a POR before replacing a
second component listed above. If this procedure is not followed, the printer will be rendered inoperable. Never
replace two or more of the components listed above without a POR after installing each one, or the printer will be
rendered inoperable.
Warning: Never install and remove components listed above as a method of troubleshooting components. Once a
component has been installed in a machine, it cannot be used in another machine. It must be returned to the
manufacturer.
Warning: Ensure the interconnect card assembly is removed from the defective RIP card assembly and installed
on the replacement rip card assembly or the machine will not function.
1. Remove the two screws securing the RIP card assembly (A) to the machine.
2. Pull the two knurled thumb screws to remove the RIP card assembly (A) from the machine.
4-86
Printer Service Manual
Previous
Next
Go Back