Sensor (Tray 2 Feed-Out) Late Jam (Feeding From Tray 3) - Lexmark C935 Service Manual

Step
9 Perform a print test.
Does the error continue?
10 Perform a print test.
Does the error continue?

243.01 Sensor (tray 2 feed-out) late jam (feeding from tray 3)

Step
1 Check the media condition.
Is the media in the tray crumpled or damaged?
2 Check the media position.
Does the media touch the sensor (tray 2 feed-out)?
3 Check the sensor (tray 2 feed-out) for proper operation.
1. Enter the Diagnostics Menu.
2. Select INPUT TRAY TESTS.
3. Select Sensor test.
4. Select Tray 2.
5. Select Feed-out.
Does the display on the operator panel, change every
time the sensing area of the above sensor is interrupted
or blocked?
4 Check the sensor (tray 2 feed-out) for proper
connection.
Is the above component properly connected?
Check
Check
Yes
Replace the 1TM Problem solved.
controller card
assembly or the 3TM
controller card
assembly or the TTM
controller card
assembly.
Go to "1X 500-
sheet drawer
(1TM)—1TM
controller card
assembly removal"
on page 4-209"3X
500-sheet drawer
(3TM)—3TM
controller card
assembly removal"
on page 4-189 or
"2000-sheet dual
input (TTM)—TTM
controller card
assembly removal"
on page 4-163.
Go to step 10.
Replace the lower Problem solved.
printer engine card
assembly.
Go to "Lower
printer engine card
assembly removal"
on page 4-93.
Yes
Replace the Go to step 2.
damaged media with
new.
Remove the media. Go to step 5
Go to step 5. Go to step 4.
Replace the sensor Replace the
(tray 2 feed-out). connection.
Diagnostic information
5057-XXX
Previous
No
Next
Go Back
No
2-43