Cmyk Pc Cartridge Drive Motor Assembly Removal - Lexmark C935 Service Manual

CMYK PC cartridge drive motor assembly removal

Warning: Ensure that all four PC cartridges are concealed from all sources of light, or damage will occur.
1. Remove the four PC cartridges from the machine.
2. Remove the rear upper cooling fan bracket assembly. See
removal" on page
3. Remove the developer / transfer roll HVPS card assembly. See
assembly removal" on page
4. Remove the lower printer engine card bracket assembly. See
removal" on page
5. Remove the 5V LVPS card bracket assembly. See
page 4-97.
6. Remove the transfer belt drive motor cooling fan. See
page 4-93.
7. Remove the transfer belt drive motor assembly. See
page 4-94.
8. Remove the K developer transport drive motor assembly. See
assembly removal" on page
9. Remove the two connectors from the CMYK PC cartridge drive motor assembly (A).
10. Release the hook securing the access cover (B) to the machine.
11. Remove the access cover (B).
12. Remove the two screws securing the socket (C) to the machine.
13. Detach the socket (C) from the machine.
Note: The lower left screw can be accessed through the hole in the frame where the socket (B) was detached
in step 7.
14. Remove the eight screws securing the CMY PC cartridge drive motor assembly (A) to the machine.
15. When removing the CMYK PC cartridge drive motor assembly (A), ensure none of the harnesses become
damaged.
4-111.
4-112.
4-92.
4-106.
A
"Rear upper cooling fan bracket assembly
"Developer / transfer roll HVPS card
"Lower printer engine card bracket assembly
"5V LVPS card bracket assembly removal" on
"Transfer belt drive motor cooling fan removal" on
"Transfer belt drive motor assembly removal" on
"K developer / transport drive motor
5057-XXX
4-101
Repair information
Previous
Next
Go Back