Developer Hold Down Removal - Lexmark CS720 Service Manual

6
Remove the rear left screw (E) from the printhead.
Installation note: When installing the printhead, replace the screws but do not tighten them right away.
After installing the screws, turn the printhead clockwise until it stops before tightening the screws fully.
After performing these steps, you may need to align the printhead if there is skew. You will also need to
perform (TBD).

Developer hold down removal

1
Remove the top cover. See
2
Remove the controller board shield. See
3
Remove the printhead. See
4
Pull the bell crank and spring off the mounting pin.
"Top cover removal" on page
"Controller board shield removal" on page
"Printhead removal" on page
Repair information
363
268.
361.
5028
356.