Sensor (Media Level) Late Error (Tray 2) - Lexmark C935 Service Manual

Step
4 Check the tray 2 switch (media size) for proper connection.
Is the above component properly connected?
5 Perform a POR.
Does the error continue when the power is turned off/on?

942.01 Sensor (media level) late error (tray 2)

Step
1 Check the media.
Is media loaded in tray 2 properly?
2 Check the sensor (media level) (tray 2) for proper operation.
1. Enter the Diagnostics Menu.
2. Select INPUT TRAY TESTS.
3. Select Sensor Test.
4. Select Tray 2.
5. Select Media level.
Does the display on the operator panel, change every time
the media tray is opened and closed?
3 Check the sensor (media level) (tray 2) for proper
connection.
Is the above component properly connected?
4
Check the media feed/lift motor (tray 2) for proper
operation.
1. Enter the Diagnostics Menu.
2. Select MOTOR TESTS.
3. Select Tray 2 media feed/lift motor.
Warning: The media tray must be opened before performing
this test or paper jam may occur.
Does the above component operate properly?
Check
Check
Caution: When performing motor tests,
ensure that all cover and door interlock
switches are overridden.
Yes
Replace the switch Replace the
(media size). connection.
Go to "Switch
(media size)
removal" on
page 4-121.
Replace the upper Problem solved.
printer engine card
assembly.
Go to "Upper
printer engine
card assembly
removal" on
page 4-90.
Yes
Go to step 2. Load media
properly.
Go to step 4. Go to step 3.
Replace the Replace the
sensor (media connection.
level).
Go to "Sensor
(media level)
removal" on
page 4-24.
Go to step 6. Go to step 5.
Diagnostic information
5057-XXX
Previous
No
Next
Go Back
No
2-115