Developer Hold Down Removal - Lexmark CX725 Service Manual

6
Remove the rear right screw (D) from the printhead.
7
Remove the rear left screw (E) from the printhead.
Installation notes:
a
When installing the printhead, replace the screws but do not tighten them right away. Install each screw
first before fully tightening all the screws.
b
Perform printhead alignment and adjustment after installing the printhead.

Developer hold down removal

1
Remove the output bin cover. See
2
Remove the controller board shield. See
3
Remove the printhead. See
"Output bin cover removal" on page
"Controller board shield removal" on page
"Printhead removal" on page
Repair information
415
330.
413.
7528
408.