4093/4094
Printhead Carrier Assembly Removal
1. Remove all covers (except the base), refer to
(Complete) Removal" on page
2. Unlock the three printhead cable connectors and disconnect the
printhead cable from the system board.
3. Remove the spring clips from the ends of the carrier guide rod
and move the carrier to the left.
4. Remove the carrier guide rod by sliding it to the left.
5. Remove the carrier assembly by lifting upward, taking care to
clear the encoder strip before pulling the carrier assembly out.
6. Disconnect the carrier belt.
7. When installing the belt, connect the carrier between the two
raised markers on the belt.
"Covers
4-5.
Repair Information
4-13