Fuser Drive Motor Assembly Removal; Toner Meter Cycle (Tmc) Card Removal - Lexmark CS310 Service Manual

Fuser drive motor assembly removal

1
Remove the right cover assembly. See
2
Disconnect the cable (A) from the fuser drive motor assembly.
Note: If you remove the toroid (B) from the cable, be sure to return the toroid to the cable when reinstalling.
3
Remove the two screws (C).
4
Remove the fuser drive motor assembly.

Toner meter cycle (TMC) card removal

1
Remove the imaging unit. See
2
Remove the rear cover. See
3
Disconnect the TMC cable from JCTM1 connector (A), and push the toner meter cycle card cable through the frame
opening.
Note: Pay close attention to the routing of the cable for reinstallation.
"Right cover assembly removal" on page
"Imaging unit (IU) removal" on page
"Rear cover removal" on page
Repair information
234
232.
246.
290.
5027