Chapter 5 — Network Support
178
Configuring Microsoft Security
The default security setting is Funk. If you want to use Microsoft security,
you need to select it as your security choice.
Intermec recommends that you use Intermec Settings to configure your
security. For more information, see the Intermec Computer Command
Reference Manual.
To enable Microsoft Security
1 Select Start > Settings > the System tab > the Intermec Settings icon.
2 Tap (+) to expand Communications > 802.11 Radio > Security
Choice.
3 Select "Microsoft Security" from the drop-down list, then press Enter.
4 Tap Yes or press Esc to clear the alert box, save your settings, then
perform a clean boot on the CN3. See
for more information on performing a clean boot.
You can configure Microsoft Settings using Intermec Settings. However,
with Intermec Settings, you cannot detect preferred networks (networks
already configured), and WPA2-PSK is not provided.
When Microsoft Security is enabled, you can use the Wi-Fi applet to
configure your preferred networks. See
on page 180
for more information.
"Clean Boot Process" on page 29
"Configuring Preferred Networks"
CN3 Mobile Computer User's Manual