Understanding Software Feature Descriptions - Intermec CN3 User Manual

CN3 Mobile Computer User's Manual
3 By default, components already installed on the CN3 are checked to be
installed again after you perform a clean boot on the CN3.
Check additional components you do want installed after a clean boot is
performed. Clear (uncheck) any components you do not want installed
after the clean boot.
Note: When a component is not checked, the components listed after
this component will appear as if they are not checked after the clean boot
is performed. However, if you had checked these components before the
clean boot, they will have been installed on the CN3 after the clean boot.
4 Click Apply to initiate the clean boot and install only the files that are
checked. Click Cancel to disregard any selections you made and close
the InstallSelect application.
5 If you clicked Apply, then click Yes to continue with the clean boot.
After the CN3 has finished with its clean boot, you should find all of the
checked components installed.

Understanding Software Feature Descriptions

The following table shows the friendly name that you may see in
InstallSelect and its underlying filename. Note that the list of files varies by
product so you will see a different list on the CN3 versus the CV30 Fixed
Chapter 3 — Configuring the Computer
85