Creating A Debug Log For Funk Security; Configuring Microsoft Security - Intermec CN3 Series User Manual

Chapter 3 — Configuring the Computer
96

Creating A Debug Log for Funk Security

If you reach a situation where you need to send in debug
information to Intermec Product Support, you can use the
Intermec Funk Security logging feature.
To enable the logging feature
1 In the Profile Wizard, select the Advanced tab.
2 Select Enable Logging and then tap OK.

Configuring Microsoft Security

The default security setting is Funk. If you want to use Microsoft
security, you need to select it as your security choice. After you
select Microsoft as your security choice, you will be prompted to
save your settings and reset your computer for your change to
take effect.
To select Microsoft security as your security choice
1 Select Start > Settings > the System tab > Intermec Settings.
The Intermec Settings application appears.
2 Select Communications > 802.11 Radio > Security Choice.
3 From the Security Choice list, select Microsoft Security and
save your settings. An alert box appears telling you that you
must save your settings and warm boot the CN3 for the new
security choice to take effect.
4 Tap Yes. The CN3 resets and starts with Microsoft Security as
the Security Choice.
Networks already configured are preferred networks. You can
connect to only preferred networks or search for and connect to
any available network.
You can add a wireless network when the network is detected or
manually by entering settings information. To determine if
authentication information is needed, see your network
administrator.
CN3 Series Mobile Computer User's Manual