Using The Storage Card - Intermec CN3 User Manual

Chapter 1 — Using the Computer

Using the Storage Card

24
The left Notification LED lights up with orange to notify you of a pending
alarm or message, such as when you receive an e-mail or set a calendar
reminder.
The CN3 uses a miniSD card to increase file storage and install software.
The miniSD card slot is located under a door that is beneath the battery
pack. Remove the two screws holding the door to reach the miniSD card.
You can corrupt your miniSD card if you do not follow these
installation and removal procedures exactly. Before installing a miniSD
card, inspect the gasket on the door for any damage or wear, and
contact your Intermec representative if any damage or wear is found
Note: The CN3 will reset if the miniSD/SIM door is opened. The screws
to this door must be in place and torqued to 1.5 in-lbs to ensure normal
operation.
To insert the miniSD card
1 Press the power button to suspend the CN3, then remove the battery
pack from the back of the CN3.
2 Remove the two screws on the miniSD/SIM card slot door.
3 Gently lift the door to the card slot, then with the metal contacts facing
down, insert the miniSD card into the card slot connector until the card
lifts up from the floor of the card slot.
4 Press the miniSD/SIM card slot door down, insert the two screws,
reinsert the battery pack, then press the power button.
Once the door to the miniSD is opened (for changing, installing, or
removing the SIM or miniSD card); a cold-boot is performed.
miniSD/SIM door
miniSD card slot
To remove the miniSD card
1 Press the power button to suspend the CN3.
2 Remove the battery pack.
3 Remove the two screws on the miniSD/SIM card slot door.
4 Remove the miniSD card from the CN3.
SIM card slot
CN3 Mobile Computer User's Manual