Viewing Sf51 Scanner Information From Your Computer - Intermec CN3 User Manual

Chapter 3 — Configuring the Computer

Viewing SF51 Scanner Information from Your Computer

100
4 The connection label for the SF51 appears to the right in EasySet,
similar to the following. Scan the label once, then confirm the blue
Intermec Ready-to-Work™ indicator on the SF51 starts blinking, which
means it is trying to connect.
5 Enter the passcode number when prompted. The default is "0000."
6 When connected, the blue Intermec Ready-to-Work indicator turns on
and stays on.
Note that in the CN3, Intermec Settings can display up to seven separate
SF51 connections. The following illustration shows such connections
under the Data Collection option.
Tap Data Collection, then tap (+) to expand the SF51 Scanner
connections to view MAC addresses, firmware version numbers, and
whether each scanner is connected to the CN3. When you clear (uncheck)
Enable scanner port, the SF51 is disconnected from the CN3. Check
Enable scanner port again to reconnect.
If you want to rename these connections to descriptions more suitable for
your situation, press the stylus on each SF51 Scanner connection for a
pop-up menu, then select Rename. Enter the description, tap ok to save.
When the SF51 is connected, configuration changes take effect
immediately. When the SF51 is not connected, configuration changes take
effect once the SF51 is reconnected.
CN3 Mobile Computer User's Manual