Intermec CN3 User Manual page 169

CN3 Mobile Computer User's Manual
AP
Status Shows whether the radio is associated with the access point
Channel The channel on which the radio is communicating with the access point
ESSID The text SSID (Network Name) for your network
BSSID MAC address of radio AP with which the client radio is communicating
Config
Association Shows one of the following types:
Open, WPA, WPA-PSK, WPA2, Network EAP
Note that more information about these types start on
Encrypt Shows potential encryptions for the association shown:
Key Absent/WEP, TKIP, Key Absent, TKIP/AES, WEP
Power CAM (Constantly Awake Mode) or FAST PSP (Power Save Poll)
Antenna Diversity (multiple antennas), Primary (one antenna)
RF
TX Power Transmit power level in milliwatts (mW).
RSSI The Received Signal Strength Indicator. The closer to zero, the better.
For example: -40dBm is excellent, while -60dBm is good.
Link The data rate at which the radios are communicating
To use the WiFi Scan tab
Use the WiFi Scan tab to scan your network and bring back information
about any access points with which you can communicate. See
Network" on page 185
Tap Scan, then wait for the table to fill with information. Tap any of the
columns to sort by ascending or descending order. Tap the slider bar on the
bottom to scroll left and right to view all of the information.
for information on connecting with a network.
Chapter 5 — Network Support
page 186
"Wireless
.
155