Enabling Bluetooth After A Clean Boot - Intermec CN3 User Manual

Enabling Bluetooth After a Clean Boot

CN3 Mobile Computer User's Manual
In the Wireless Manager, either tap All or tap Bluetooth, then wait for
"On" to appear beneath the Bluetooth row.
Once activated, information appears in the Today desktop like the
following. Note the Bluetooth icon is on the right.
Tap Menu > Bluetooth Settings to perform a device search (more
information on the next page). Tap Done to close the Wireless Manager.
Bluetooth is not started by default after a clean boot is performed.
To enable Bluetooth
• Tap Start > Settings > the Connections tab > the Bluetooth icon.
The CN3 retains the Bluetooth state when clean boots are performed, for
example:
• If Bluetooth was enabled before a clean boot was performed, the CN3
boots up with the Bluetooth state enabled and Bluetooth virtual COM
ports (such as printing) registered. Reactivate the connections manually
as the system does not do them.
• If Bluetooth was disabled before a clean boot was performed, the CN3
boots up with Bluetooth disabled.
To turn on Bluetooth
• Select Start > Settings > the Connections tab > the Bluetooth icon >
the Mode tab, then check Turn on Bluetooth.
• If the CN3 is to be found by other Bluetooth devices that require such
visibility, then check Make this device visible to other devices.
Chapter 5 — Network Support
115