Pinging - Intermec CN3 User Manual

Ping Information
Status
Timing Statistics
BSSID
Channel
RSSI
Link
CN3 Mobile Computer User's Manual
• Click Configure Profile to launch the Profile Wizard and configure
802.11 options. See
information on configuring this wizard.
• Click Reconnect to disassociate the radio, momentarily dropping its
connection. The radio then reassociates and reauthenticates, but does
not do anything with the radio driver.
• Click Clear Events to remove the information shown in the Supplicant
Event box.

Pinging

Use the Ping tab to contact with any host in your network for information.
Description
Min: The shortest ping reply in milliseconds (ms)
Max: The maximum ping reply in milliseconds
Avg: The average ping reply time
Count: The number of pings already completed
Timeouts: The number of pings that did not receive a response
The MAC address for the access point radio
The channel on which the access point is communicating
The RSSI seen on the access point
The speed at which the last ping occurred
To ping a host
1 From the Host drop-down list, select an IP address for the host you want
to ping. Enter a new IP address using the input panel or the keypad.
Select Clear List to remove all the IP addresses from the drop-down list.
2 From the Repetitions drop-down list, select the number of times to ping
the selected host. These repetitions are done once per second.
3 Tap Ping to initiate contact with the selected host.
"Using the Profile Wizard" on page 164
Chapter 5 — Network Support
for
157