Table of Contents
Advertisement
8C - 8
CHARGING SYSTEM
REMOVAL AND INSTALLATION (Continued)
(6)
Remove generator from vehicle.
(7) Reverse removal procedures to install . Tighten
generator hardware as follows :
" Generator upper mounting bolt-All engines - 55
N-m (41 ft . lbs .)
" Generator lower mounting bolt -All engines -
55 N-m (41 ft. lbs .)
" Battery terminal nut - 8 .5 N-m (75 in. lbs .)
" Ground terminal nut - 8 .5 N-m (75 in . lbs.)
" Harness hold-down nut - 8 .5 N-m (75 in . lbs .)
" Field terminal nuts - 2 .8 N-m (25 in . lbs .)
CAUTION : Never force a belt over a pulley rim
using a screwdriver. The synthetic fiber of the belt
can be damaged .
CAUTION :
When installing a serpentine accessory
drive belt, the belt MUST be routed correctly. The
water pump will be rotating in the wrong direction if
the belt is installed incorrectly, causing the engine
to overheat. Refer to belt routing label in engine
compartment, or refer to Belt Schematics in Group
7, Cooling System .
BATTERY TEMPERATURE SENSOR
The battery temperature sensor is located under
the vehicle battery and is attached to a mounting
hole on battery tray.
REMOVAL
(1)
Remove the battery. Refer to Group 8A, Battery
for procedures.
SPECIFICATIONS
GENERATOR RATINGS
TYPE
DENSO
DENSO
TORQUE CHART
PART NUMBER
56005684
56005685
Description
Torque
Generator Upper Mounting Bolt-
2 .5L/4.OL Engine . . . . . . . . . . . . 55 N-m (41 ft . lbs .)
Generator Lower Mounting Bolt-
2 .5L/4.OL Engine . . . . . . . . . . . . 55 N-m (41 ft . lbs .)
Battery Terminal Nut . . . . . . . . . 8 .5 N-m (75 in . lbs .)
Ground Terminal Nut . . . . . . . . . 8 .5 N-m (75 in . lbs .)
Harness Hold-down Nut . . . . . . . 8 .5 N-m (75 in . lbs .)
Field Terminal Nuts . . . . . . . . . . 2 .8 N-m (25 in . lbs .)
RATED SAE
AMPS
81
117
BATTERY
TEMPERATURE
SENSOR
TJ
Fig. 5 Battery Temperature Sensor Removellnstall
(2) Disconnect the sensor pigtail harness from the
engine wire harness .
(3) Pry the sensor straight up from the battery
tray mounting hole .
INSTALLATION
(1)
Feed the pigtail harness through the hole in
top of battery tray and press sensor into top of bat-
tery tray.
(2) Connect the pigtail harness .
(3) Install the battery. Refer to Group 8A, Battery
for procedures.
ENGINES
MINIMUM TEST
AMPS
2 .5U4 .0L
75
~ .
. 2
.5 V4 .OL
I
90
Advertisement
Table of Contents
Troubleshooting
