MV Agusta Brutale 990 R Workshop Manual page 96

- Press "OK" for over four seconds; the value of the
mileage will start flashing.
B
- By pressing "OK" once more, the mileage is reset to
the prescribed value of the distance to be covered in
order to undergo the next scheduled service.
"TC" Mode
- Press "SET" in order to access "TC" mode, then press
"SET" for over four seconds until "TC LEVEL"
appears. The current traction control level is the same
as the one shown on the display.
The display modes may be changed or set
when the engine is off, the gears are in neu-
tral, the motorbike is stationary, and with
your feet on the ground. Do not change the
display while driving.
Maintenance
- 80 -