MV Agusta Brutale 990 R Workshop Manual page 221

Remove the screw ring previously slackened and
remove the steering base complete with the pin.
Remove the anti-dust seal, the internal bearing ring
and the ball bearing ring.
If it is necessary to replace the steering base comple-
te with pin, you must remove the parts of the lower
steering bearing according to the procedure described
as follows.
Remove the internal bearing ring and the ball bearing
ring from the pin of the steering base previously remo-
ved from the bike.
Place the steering base on the corresponding support
plate (special tool).
Special tool No. 800097888
Insert the steering pin bearing extractor (special tool)
on the steering base pin.
Special tool No. 800097889
Couple the two half-shells on the extractor as descri-
bed in the figure.
Insert the extractor ring on the half-shells.
Special tool No. 800097889
Suspension and wheels
- 27 -
F