MV Agusta Brutale 990 R Workshop Manual page 51

Position the flange unit (1) inside the fuel tank.
Check that the two small overflow tubes (2) remain out-
side of the fuel tank.
Insert two CLIC R 96 105 band fasteners (1) onto the
small tubes. Insert the two small rubber tubes (2) onto
the appropriate spigot on the die-cast flange. Tighten
the band fasteners by using the CLIC 205 pincers.
Specific pliers: CLIC R 205
Part code 800095850
Insert the flange unit into its seat on the tank. Insert the
three spacers into their respective slots located on the
flange. Screw and tighten the eight fixing screws.
Torque wrench of fuel pump flange fixing
screws: 6 ÷ 8 N·m
Proceed with the assembly of the parts removed by fol-
lowing the removal operation in reverse order to that
shown in chapter C "Bodywork":
• Fuel tank
• Tank side panel
• Ignition switch cover
• Rider seat
• Passenger seat
Maintenance
- 35 -
1
2
6 ÷ 8 N•m
1
B
2