Replacing the high beam bulb
- Remove the headlight from its support as described
for the hgh beam.
- To take the headlight lamp out, press the connector
on the side and pull it outwards.
- Detach the connector from the burnt-out bulb.
Do not touch the bulb glass with bare hands.
If you do, clean the bulb with an oil-free sol-
vent.
- Insert the connector in the new bulb.
- Fit the lamp back in and slightly press it into its hou-
sing to secure it.
- Replace the headlight on its support, following the
instructions described for the hgh beam.
Replacing the license plate light bulb
- Remove the cable rail fixing screws.
- Pull down the cable rail and detach it from the upper
surface, operating as described in the picture.
Maintenance
- 87 -
B