MV Agusta Brutale 990 R Workshop Manual page 230

Rear suspension adjustment
The following operations can be also car-
N.B.
ried out with the rear shock absorber
assembled to the motorcycle.
Rebound damper (rear suspension)
The adjustment can be performed by operating on the
screw placed on the lower side of the shock absorber,
and it is obtained from the standard position.
This position is found by fully rotating the screw clockwi-
se and then counterclockwise until you hear the first click;
from this position, turn the screw counterclockwise until
you reach the standard position (see tabl
Rotate clockwise to increase the damping action or coun-
terclockwise to decrease it.
High speed compression damper (rear suspension
F
Brutale 1090 RR)
The adjustment can be performed by operating on the
ring nut placed on the upper side of the shock absor-
ber, and it is obtained from the standard position.
This position is found by fully rotating the nut counter-
clockwise and then clockwise until you hear the first
click; from this position, turn the nut clockwise until you
reach the standard position (see t
Rotate clockwise to increase the damping action or
counterclockwise to decrease it.
Low speed compression damper (rear suspension
Brutale 1090 RR)
The adjustment can be performed by operating on the
screw placed on the upper side of the shock absorber,
and it is obtained from the standard position.
This position is found by fully rotating the s crew
clockwise and then counterclockwise until you hear the
first click; from this position, turn the screw counter-
clockwise until you reach the standard position (see table
at page 37). Rotate clockwise to increase the damping
action or counterclockwise to decrease it.
Suspension and wheels
e at page 37 ).
able at page 37).
- 36 -