MV Agusta Brutale 990 R Workshop Manual page 260

Reposition the nut of the flange (1) with the relative
washer (2) without tightening.
Using the special spanner, bring the eccentric back
F
into position by rotating in an anti-clockwise direction to
tighten the chain.
Special tool:
Spanner for eccentric hub
Extension for spanner
Whenever the chain is tightened, it is neces-
sary to adjust the stability of the vehicle -
see "Adjusting vehicle stability" in this
chapter.
Tighten the wheel pin fixing nut by rotating it clockwise
as shown in the figure, by using the following tools:
• Torque wrench
• 55 mm polygonal socket wrench
Slip flange nut coupling torque:
200-220 Nm
Apply grease only on the threaded part
Suspension and wheels
N. 800092854
N. 800092855
- 66 -
2
200÷220 N•m
1