MV Agusta Brutale 990 R Workshop Manual page 83

Selecting and setting the display functions
Some of the main measurements of the instruments
may be changed.
The available options include:
- Select an operating mode:
"RUN" (Odometer)
"CHRONO" (Chronometer)
"SERVICE" (Expiration of scheduled maintenance
service)
"TC" (Traction control)
"IMMOBILIZER" (Antitheft device)
- Reset the trip counter:
Trip counter 1 "TRIP 1"
Trip counter 2 "TRIP 2
- Set the measurement units for
Speed
Distance covered
- Turn on the chronometer
- Control unit mapping selection *
Selecting the display functions
The following settings may be changed on the display:
• "RUN" (Odometer)
• "CHRONO" (Chronometer)
• "SERVICE" (Expiration of scheduled maintenance
service)
• "TC" (Traction control)
• "IMMOBILIZER" (Antitheft device)
To display the operating modes, press "SET" for less
than four seconds. When pressed, the display shows
all modes, in a sequence. Select the desired mode.
The operation must be performed while the
engine is off, the gears are in neutral, the
motorcycle is stationary, and with your feet
on the ground. Do not set the display func-
tions while riding.
(*): This function is present only on certain models
Maintenance
- 67 -
B