Bobbin Thread Clamp - VETRON 5000 Service Manual

DISPLAY
»

BOBBIN THREAD CLAMP

01
02
2 8 B o bi b n t h ea r d
03
c l a m p s tup e
04
05
06
07
GENERAL:
In resting position
A
line without pressure. After the thread cutting procedure the bobbin thread should
be securely held.
1
3
STEP
Activate the ADJUSTMENT WIZARD
(02.04. / Page 17).
» until chapter 28 appears
on the display.
» confi rm.
Turn the machine by hand that the thread cutting operation is safely completed.
Loosen screw 3 and turn the bobbin thread clamp
touches the thread catcher in line
Fix screw 3 again.
INFO:
The bobbin thread should not be clamped too hard. After the fi rst stitch the needle
thread should have pulled it out of the clamp.
» confi rm to proceed to the next point.
03. ADJUSTMENT
2 the bobbin thread clamp
2
A
DESCRIPTION
until it
1
A .
03.28. BOBBIN THREAD CLAMP
1 should touch the thread catcher in
INFO: Stitch length is set to
0 mm, pedal is blocked,
the display shows the machine
position in degrees.
SERVICE MANUAL VETRON 5000 63