Basic Adjustment Of The Feed Shaft Clamp - VETRON 5000 Service Manual

03. ADJUSTMENT

03.10. BASIC ADJUSTMENT OF THE FEED SHAFT CLAMP

GENERAL:
At stitch length 0 the gap of the clamp
of the main motor.
DISPLAY
» BASIC ADJUSTMENT OF THE FEED SHAFT CLAMP
01
02
1 0 F e d e d r i v e
03
c l a m p p s setup o
04
05
06
07
44 SERVICE MANUAL VETRON 5000
1 should have a distance of 18 mm to the edge
STEP
Activate the ADJUSTMENT WIZARD
(02.04. / Page 17).
» until chapter 10 appears
on the display.
» confi rm.
3
Loosen the screws and position the gauge
as shown in the picture.
1
Turn the clamp until the gap matches
with the mark on the gauge
In this position fi x the screw
INFO:
After this adjustment the following adjustment step 03.11. must be performed (again).
» confi rm to proceed to the next point.
DESCRIPTION
2
2
.
3 .
1
3
2
INFO: The pedal is blocked. During
turning by hand the display shows
the machine position in degrees.
Stitch length is set to 0 mm. The
tilt blocking mechanism is not
active.