Typical Operating Field - VETRON 5000 Service Manual

01. OPERATING ELEMENTS
01.02. TYPICAL OPERATING FIELD P107
The operating fi eld indicates the current operating states.
Operation takes place via continuous dialog between control and operator.
Depending on the operating state, di erent texts are displayed.
The following functions are assigned to the BUTTONS ABOVE AND BELOW THE DISPLAY:
1 BACKTACK (from left to right):
1. Start backtack
2. End backtack
2
THREAD TRIMMING
3
NEEDLE UP/DOWN AFTER STOP
4
LIGHT ON/OFF
5
PARAMETERS
6 NEW PROGRAM
7 PROGRAMMED SEAM
8
SAVE
9
CANCEL
If a function is activated, this is indicated by illuminating the corresponding LED.
In order to CHANGE OR SET VALUES, use the JOG Key (
Turning changes the values; pressing the JOG Key enters the value.
In the following, the operating type is indicated by the following icons:
Input = Press the JOG Key:
Change = Turn the JOG Key:
08 SERVICE MANUAL VETRON 5000
1 2 3 4
A B
P 000 30%
T E T S
ESC
5 6 7 8 9
10
):
10