Thread Catcher Resting Position - VETRON 5000 Service Manual

03. ADJUSTMENT

03.27. THREAD CATCHER RESTING POSITION

GENERAL:
In resting position of the thread catcher
in line with the point of the thread catcher
1
2
A
DISPLAY
» THREAD CATCHER RESTING POSITION
01
02
2 7 T h ea r d c a ch t
03
r e s t p o s setup
04
05
06
07
08
62 SERVICE MANUAL VETRON 5000
1
the cutting edge of the knife
1
3
STEP
Activate the ADJUSTMENT WIZARD
(02.04. / Page 17).
» until chapter 27 appears
on the display.
r
» confi rm.
Turn the machine by hand that the thread cutting operation is safely completed.
Loosen screw 3 .
Move the thread catcher
line with the cutting edge of the knife as shown in image 1.
With attention to the secure touching of the roller lever
at the control cam
ATTENTION:
Avoid vertical play.
» confi rm to proceed to the next point.
2
( A ).
1
until this point is in
5 , fi x screw 3 again.
should be
DESCRIPTION
INFO: Stitch length is set to
0 mm, pedal is blocked,
the display shows the machine
position in degrees.
4
4
5