Adjustment Of The Feed Dog Position Inside The Stitch Plate - VETRON 5000 Service Manual

1 2
DISPLAY
»

ADJUSTMENT OF THE FEED DOG POSITION INSIDE THE STITCH PLATE

01
02
1 5 F e d e d o g p os
03
s e t u p
04
05
06
07
08
09
10
03.15. ADJUSTMENT OF THE FEED DOG POSITION INSIDE THE STITCH PLATE
GENERAL:
At stitch length 0 the feed dog should be positioned in the middle of the hole in both
directions as shown in image 3.
3
STEP
Activate the ADJUSTMENT WIZARD
(02.04. / Page 17).
» until chapter 15 appears
on the display.
» confi rm.
1
Loosen the screw and the screws
While fi xing the feed dog with its screws make sure that
they are in the middle of their hole.
Fix the stitch plate to the machine.
Turn the needle bar with the gauge pin
into the needle hole.
2
Move the feed dog carrier
gauge pin exactly in the middle of the needle hole.
4
Make sure that the feed dog is not touching the stitch
1
plate fi x the screws and
» confi rm to proceed to the next point.
03. ADJUSTMENT
DESCRIPTION
3
.
downwards
4
to position the
3
.
4
INFO: The pedal is blocked. During
turning by hand the display shows
the machine position in degrees.
Stitch length is set to 0 mm. The
tilt blocking mechanism is not
active.
SERVICE MANUAL VETRON 5000 49