Table of Contents
Advertisement
Before Starting to Use
Safety Guide - Installation
This section describes the precautions to be observed when installing the machine. Read this section before install-
ing the machine.
Note:
• Your dealer (or authorized service representative) will help you to determine a proper location for the machine at
the time of delivery.
Installation
A
WARNING:
• Place the machine on the dedicated stand for this model or on a flat and stable surface (maximum of 10 mm (
inches) differential allowed). Injury might occur if the machine falls.
B
Caution:
• Install the machine near the electrical outlet to avoid using an extension cord between the machine and the elec-
trical outlet.
• Allow at least 10 cm (4 inches) or more of clearance behind the machine so that you can unplug the machine in
case of technical difficulties.
• Keep the machine away from dusty environments. Failure to do so may result in fire.
• Install the machine in a well-ventilated area.
Important!:
• Avoid installing the machine in the locations listed below. Failure to observe this precaution may lead to machine
failure.
– Locations with exposure to direct sunlight, such as locations close to windows (Curtain all windows that might
expose the machine to direct sunlight)
– Locations that are subject to sudden changes in temperature
– Extremely hot and humid locations or cold and dry locations
– Heated locations
– Locations exposed to direct cold air, direct hot air, or direct radiant heat
– Poorly ventilated locations
Power connection
A
WARNING:
• Use with the machine's rated voltage value. Also, plug into an electrical outlet with a capacity larger than the rated
current value.
For the rated voltage value and rated current value, check the "Power Source" entry of the Specifications at the end
of this manual.
• Do not overload the electrical outlet or extension cord, nor damage the power cord by placing heavy objects on it
or pulling or bending it. This can result in fire or electric shock.
• Do not pull the power cord but hold the plug itself when unplugging it. This can damage the cord and result in fire
or electric shock.
• Do not plug or unplug the power cord if your hands are wet. This can result in electric shock.
10
Safety Guide - Installation
/
25
64
Advertisement
Table of Contents
Troubleshooting
