Riso SE 9480 User Manual page 226

Troubleshooting
Message
Master Mis-Feed
Pull Out Master Making Unit and
Rewind Master Roll, then
Reset Master in Place
Master Not Set in Place
Insert Lead Edge of Master into
Master
Entrance and Close Master Making
Unit
Master Remains on Print Drum
Pull Out Print Drum and
Remove Master
Paper Jam
Remove Paper in Indicated Areas
and Press [OK] Button
Safety SW on Paper Feed Tray
is Activated
Reset paper on Paper Feed Tray
System Error in Master Making Unit
Take Out Master and then
Close Master Making Unit Cover
B00-000:Optional Device Error (in alphabetical order)
Message
Can not identify
Can not identify (USB hub)
Insert Card in Key/Card Counter
224
When a Message Displays
Possible Cause
The master is improperly
installed.
The master is improperly
installed or is missing.
An unnecessary master
remains on the Print Drum
(Cylinder).
Paper jammed in indicated
area.
The safety switch for the Paper
Feed Tray has been activated.
The cutter mechanism for the
master malfunctioned.
Possible Cause
• Something other than a USB
Flash Drive is connected to
the USB slot.
• A defective USB Flash Drive
is connected to the USB slot.
• A USB Flash Drive not
recognized by this machine is
connected to the USB slot.
A USB hub is connected to the
USB slot.
No card in the Key Card
Counter (option).
Action
Pull out the Master Making Unit, rewind
the master and reinstall.
p.204
Pull out the Master Making Unit and
reinstall the master.
p.204
Important!:
• If the leading edge of the master is
wrinkled or torn, cut the edge straight
and reinstall.
1)
Pull out the Print Drum (Cylinder) and
remove the master from the Print Drum
(Cylinder).
p.211
2)
Return the Print Drum (Cylinder) in place.
3)
Press the key.
1)
Remove the jammed paper.
2)
Press the key or touch [OK].
Check underneath the Paper Feed Tray
and on top of the printing paper for any
obstructions. Remove if any exists.
Pull out the Master Making Unit and
remove the master.
p.204
Closing the Master Making Unit Cover will
reset the error. Setup the master again.
Action
Connect a USB Flash Drive for this
machine.
p.46
Connect the correct corresponding USB
Flash Drive.
p.46
Insert Card in the Key Card Counter.