Riso SE 9480 User Manual page 237

Message
Enter Print Quantity Over [N],
Programed Minimum Value
!! Images may not fit
in Frame of Paper with
This Reproduction Size !!
Check Current Selection
Invalid Print Drum
has been Selected
Change Print Drum, or
Reselect Print Drum Size
!! Layout is not available
with this paper size !!
Replace with proper paper
of standard size
!! Multi-Up is Not Available
with This Paper Size !!
Replace with Proper Paper
of Standard Size
Symptom/Action
(Symptom)
You are trying to print fewer copies than
previously specified on "Minimum Print
Quantity".
(Action)
Enter a larger number to print, or change
"Minimum Print Quantity" on the Admin.
Screen.
p.171
(Symptom)
Reproduction size for the detected
original size is larger than paper size.
(Action)
Modify the reproduction size.
p.61
(Symptom)
You have selected a different Print Drum
(Cylinder) than the one currently in
place, as confirmed in the Confirm Print
Drum (Cylinder) Type screen when it
was installed.
(Action)
Select the type of Print Drum (Cylinder)
currently installed.
Alternatively, you can change the Print
Drum (Cylinder).
p.211
(Symptom)
Layout functions cannot be used when
custom-sized papers are set in the
Paper Feed Tray.
(Action)
Load standard size paper in the Paper
Feed Tray.
p.34
(Symptom)
Multi-up functions cannot be used when
custom-sized paper is in the Feed Tray.
(Action)
Load standard size paper in the Feed
Tray.
Troubleshooting
How to Clear a Pop-Up Message
Touch [Close], and specify the number
of copies higher than the number
displayed on the message.
• When resuming the print job:
Touch [Continue].
(Alternatively, press the
print.)
• When stopping the print job:
Touch [Cancel].
(Alternatively, press the
the key to clear.)
• When changing a setting:
In the Confirm Print Drum (Cylinder)
Type screen, select the type of Print
Drum (Cylinder) currently installed
and touch [OK].
• When installing a different Print
Drum (Cylinder):
Pull out the Print Drum (Cylinder) and
replace with the correct one.
When the Print Drum (Cylinder) is re-
installed, the Warning Message will
clear.
Touch [Close].
(Alternatively, press the
key to clear.)
Touch [Close].
(Alternatively, press the
key to clear.)
When a Message Displays
key to
key or
key or the
key or the
235