Table of Contents
Advertisement
Troubleshooting
Message
!! No Auto Reproduction
Size Selection with This
Combination of Original
and Printing Paper !!
Select Size Manually
!! No Auto Reproduction
Size Selection with This
Combination of Original
and Printing Paper !!
Select Size Manually
!! No Auto Reproduction
with This Original
and Printing Paper !!
Select Size Manually
No Master on Print Drum
Make a New Master
Original size exceeds
limitation of layout
Specify the original size
Original Size Exceeds
Limitation of Multi-Up
Specify Original Size
236
When a Message Displays
Symptom/Action
(Symptom)
With the size of set original and printing
paper, auto reproduction cannot be
performed.
(Action)
Modify the reproduction size.
(Symptom)
Auto Reproduction Size is less than
50% or more than 200%.
(Action)
Modify the reproduction size.
(Symptom)
Auto reproduction is not available
because the size of the original could
not be detected.
(Action)
Set the reproduction size manually.
(Symptom)
You are attempting to print, but there is
no master on the Print Drum (Cylinder).
(Action)
Set the original and create a master.
(Symptom)
"Layout" is not available for the original
size.
(Action)
Specify the original size.
p.80
(Symptom)
"Multi-Up" is not available for the original
size.
(Action)
Specify the original size.
p.71
How to Clear a Pop-Up Message
• When changing the "Size" setting:
Touch [Size Setting].
• When stopping the print job:
Touch [Cancel].
(Alternatively, press the
the
key to clear.)
• When changing the "Size" setting:
Touch [Size Setting].
• When stopping the print job:
Touch [Cancel].
(Alternatively, press the
the
key to clear.)
• When changing the "Size" setting:
Touch [Size Setting].
• When stopping the print job:
Touch [Cancel].
(Alternatively, press the
the
key to clear.)
Touch [Close].
Set the original and create a master.
Important!:
• Do not leave the Print Drum (Cylinder)
without a master. This dries out the
Print Drum (Cylinder) and causes
damage. You must either create a
master or perform a "Confidential"
operation to wrap a master around the
Print Drum (Cylinder).
• When changing the "Original Size"
setting:
Touch [Original Size].
• When resuming the print job:
Touch [Continue].
(Alternatively, press the
• When stopping the print job:
Touch [Cancel].
(Alternatively, press the
the
key to clear.)
• When changing the "Original Size"
setting:
Touch [Original Size].
• When resuming the print job:
Touch [Continue].
(Alternatively, press the
• When stopping the print job:
Touch [Cancel].
(Alternatively, press the
the
key to clear.)
key or
key or
key or
key to print.)
key or
key to print.)
key or
Advertisement
Table of Contents
Troubleshooting
