Riso SE 9480 User Manual page 229

Message
Wrong-type Master Installed
or Cannot Read Master Info
Replace Master Roll
or Contact dealer (or authorized
service representative)/Riso office
Wrong-Type Print Drum (Cylinder)
Installed
Replace with Correct Type
Possible Cause
Incorrect type of master is
installed.
The section on the master
core is missing, or it has worn
off, or it has been tilted.
Incorrect Print Drum (Cylinder)
is installed.
Action
Set a correct Master Roll.
p.204
Important!:
• Use a Master Roll specifically designed
and approved for use with this machine.
Failure to do so may cause problems or
damage to the machine.
The section on the master core
contains information needed for making
masters.
If the machine cannot read the
information, it does not operate. Set a
dedicated Master Roll that has the
mark and is free from wear and tilt.
Install a correct Print Drum (Cylinder).
p.211
Important!:
• Use a Print Drum (Cylinder) specifically
designed and approved for use with this
machine. Failure to do so may cause
problems or damage to the machine.
When a Message Displays
Troubleshooting
227