Throttle Position Sensor - Buell 2007 FIREBOLT Service Manual

HOME

THROTTLE POSITION SENSOR

REMOVAL
1. Remove air cleaner cover. See
ASSEMBLY.
2. See Figure 4-81. Disconnect throttle position sensor con-
nector [88].
3. See Figure 4-82. Remove two screws and washers to
detach TP sensor.
INSTALLATION
1. See Figure 4-82. Apply LOCTITE 222 (purple) to threads
of fasteners.
2. Install fastener into lower mounting hole of sensor prior
to installation.
3. Attach TP sensor with both fasteners and washers.
Tighten to 12-15 in-lbs (1.4-1.7 Nm).
4. See Figure 4-83. Attach throttle position sensor connec-
tor [88]. Slots on female connector [88B] must fully
engage tabs on male connector housing [88A].
NOTE
Throttle position sensor can only be calibrated using DIGITAL
TECHNICIAN (Part No. HD-44750).
5. Calibrate throttle position sensor.
12501
Figure 4-81. Throttle Position Sensor Connector Location
12502
4.44 AIR CLEANER
Figure 4-82. Throttle Position Sensor
Tab
Figure 4-83. Tabs on TP Sensor Connector [88A]
2007 Buell Firebolt: Fuel System 4-105
4.37
Tab
b0651x4x