Trouble Code 11 - Buell 2007 FIREBOLT Service Manual

HOME

TROUBLE CODE 11

GENERAL
Throttle Position Sensor
See Figure 4-31. The throttle position sensor (TP sensor) is
supplied 5.0 volts from the ECM (5v REF) and sends a signal
back to the ECM (TP sensor signal) which varies according to
throttle position. The output signal from the TP sensor varies
from:
0.5-1.5 volts at idle (closed throttle).
3.9-4.9 volts at wide open throttle.
A Code 11 will set if the TP sensor signal voltage does not fall
within the acceptable range.
NOTE
If the TP sensor is removed and/or replaced, the sensor must
be calibrated using Digital Technician (Part No. HD-44750).
For replacement of TP sensor see
TION SENSOR.
DIAGNOSTICS
Diagnostic Tips
TP sensor voltage should increase at a steady rate as throttle
is moved from idle to wide open throttle. An open or short to
ground in R/W or BK/W wires will also result in a Code 11.
Check for the following conditions:
Poor connection. Inspect ECM harness connector for
backed out terminals, improper mating, broken locks
improperly formed or damaged terminals, poor terminal-
to-wire connection and damaged harness.
Perform 4.7 WIGGLE TEST
connections and harness check out OK, monitor TP sen-
sor voltage using DVOM while moving related connec-
tors and wiring harness. If the failure is induced, the
DVOM display will change.
TP sensor scaling. Observe the TP sensor voltage dis-
play while opening the throttle with engine stopped and
ignition switch ON. Display should vary from closed throt-
tle TP sensor voltage (when throttle is closed) to greater
than 4.0 volts (when throttle is held wide open). As the
throttle is slowly moved, the voltage should change
gradually without spikes or low voltages being observed.
4.37 THROTTLE POSI-
to locate intermittents. If
12502
1
2
1. Throttle position sensor and harness
2. Throttle shaft
Figure 4-31. TP Sensor Assembly
A (R/W Wire)
b0651x4x
Figure 4-32. TP Sensor Terminals [88A]
Diagnostic Notes
The reference numbers below correlate with the circled num-
bers on the Code 11 flow charts.
1. Connect BREAKOUT BOX (Part No. HD-42682) to ECM.
See 4.6 BREAKOUT BOX.
2007 Buell Firebolt: Fuel System
4.16
C (BK/W Wire)
B (V/Y Wire)
4-43