Engine - Buell 2007 FIREBOLT Service Manual

HOME

ENGINE

FUEL
Gasoline/alcohol Blends
Buell Ulysses motorcycles have been designed to obtain the
best performance and efficiency using a good quality
unleaded gasoline. Buell recommends using at least 91 pump
octane (RON). Octane rating is usually found on the pump.
Some fuel suppliers sell gasoline/alcohol blends as a fuel.
The type and amount of alcohol added to the fuel is impor-
tant.
DO NOT USE GASOLINES CONTAINING METHANOL.
Using gasoline/methanol blends will result in starting and
driveability deterioration and damage to critical fuel sys-
tem components.
Gasolines containing
blends are mixture of 10% ethanol (Grain alcohol) and
90% unleaded gasoline. Gasoline/ethanol blends can be
used in your motorcycle if the ethanol content does not
exceed 10%.
Gasolines containing ETHER: Gasoline/ether blends are
a mixture of gasoline and as much as 15% ether. Gaso-
line/ether blends can be used in your motorcycle if the
ether content does not exceed 17%.
REFORMULATED OR OXYGENATED GASOLINES
(RFG): "Reformulated gasoline" is a term used to
describe gasoline blends that are specifically designed to
burn cleaner than other types of gasoline, leaving fewer
"tailpipe" emissions. They are also formulated to evapo-
rate less when you are filling your tank. Reformulated
gasolines use additives to "oxygenate" the gas. Your
motorcycle will run normally using this type of gas. Buell
recommends you use it when possible, as an aid to
cleaner air in our environment.
Because of their generally higher volatility, these blends may
adversely affect the starting, driveability and fuel efficiency of
your motorcycle. If you experience these problems, Buell rec-
ommends that you operate your motorcycle on straight,
unleaded gasoline.
3-6 2007 Buell Firebolt: Engine
ETHANOL: Gasoline/ethanol
ADJUSTMENT/TESTING
General
When an engine needs repair, it is not always possible to
determine definitely beforehand whether repair is possible
with only cylinder head, cylinder and piston disassembled or
whether complete engine disassembly is required for crank-
case repair.
Most commonly, only cylinder head and cylinder repair is
needed (valves, rings, piston, etc.) and it is recommended
procedure to service these units first, allowing engine crank-
case to remain in frame.
See 3.3 ENGINE ROTATION FOR SERVICE
cle for removal of cylinder head, cylinder, and piston.
After disassembling "upper end" only, it may be found that
crankcase repair is necessary. In this situation, remove the
engine crankcase from the chassis.
NOTE
If engine is removed from chassis, do not lay engine on pri-
mary side. Placing engine on primary side will damage clutch
cable end fitting. If fitting is damaged, clutch cable must be
replaced.
See 1.22 TROUBLESHOOTING
ing a need for engine repair are often misleading, but gener-
ally, if more than one symptom is present, possible causes
can be narrowed down to make at least a partial diagnosis.
An above-normal consumption of oil, for example, could be
caused by several mechanical faults. However, when accom-
panied by blue-gray exhaust smoke and low engine compres-
sion, it indicates the piston rings need replacing. Low
compression by itself, however, may indicate improperly
seated valves, in addition to or in lieu of worn piston rings.
Most frequently, valves, rings, pins, bushings, and bearings
need attention at about the same time. If the possible causes
can be narrowed down through the process of elimination to
indicate any one of the above components is worn, it is best
to give attention to all of the cylinder head and cylinder parts.
3.2
to strip motorcy-
section. Symptoms indicat-